Inserting and Removing the Battery Pack

Inserting the Battery Pack

Load a fully charged BP-511 battery pack into the camera.

Open the battery chamber cover.

• Slide the lever in the direction shown by the arrow in the diagram, and open the cover as shown.

Load the battery into the camera.

• Make sure the battery pack is facing the right way, and insert it into the battery chamber.

• Insert the battery pack until it locks into place.

Close the cover.

• Press the cover closed until it clicks shut.

CD CQ

Battery Charge Remaining Icons

The level of charge remaining is shown in three stages when the Main Switch is set to ( ON ). H33)

: Charge is sufficient. O : Charge is low. CD : Battery pack must be charged.

[=1 If the level of charge remaining runs out when you are using the menu screen or playing back an image, a no battery warning appears on the LCD monitor. When this occurs, remove the battery and charge it.

Number of Available Shots

Temperature

Shooting conditions

No flash use

50% flash use

Normal (20°C/68°F)

Approx. 680

Approx. 540

Low (0°C/32°F)

Approx. 480

Approx. 400

• The above figures were obtained under Canon test conditions (fully charged battery, EF 50mm F1.4 USM lens, Review function [On], Review Time [2 sec.], Quality [Large A ]).

• Playback on the LCD monitor is available for approximately 140 minutes at normal temperature (continuous auto playback).

• The number of available shots may be less than indicated in some cases, due to differences in operating conditions.

• The number of available shots is reduced by frequent use of the LCD monitor.

• Holding the shutter button halfway down for long periods to use the AF function without taking a shot can reduce the number of available shots.

• In low temperature conditions (0°C/32°F), the number of available shots may be less than indicated.

• For the number of available shots when using the Battery Grip BG-ED3, see the BG-ED3 User's Manual.

Removing the Battery Pack

Open the battery cover.

• Slide the lever in the direction shown by the arrow in the diagram, and open the cover as shown.

2 Remove the battery pack.

• Slide the battery lock lever in the direction shown by the arrow, and remove the battery.

3 Close the battery cover.

• Press the cover closed until it clicks shut.

Using a Household Power Supply

You can operate the EOS D30 from a household power outlet by using the DC coupler. This enables you to use the camera as long as you like without a battery.

Connect the DC coupler.

• Plug the DC coupler into the compact power adapter.

Place the cord in the groove.

• Carefully insert the cord into the groove.

CD CQ

Insert the DC coupler into the camera.

• Open the cover (^27) and lower the covering on the cord channel.

• Insert the DC coupler and fit the cord into the cord channel.

• Check that the cord is placed tightly in the cord channel, and slide the DC coupler into the chamber until it locks into place.

• Close the cover so that it clicks into place.

Connect the power cord.

• Connect the power cord to the compact power adapter.

• Plug the cord into a power outlet.

• When you are finished, remove the plug from the power outlet.

• Do not use any DC coupler other than the one provided with your EOS D30 camera.

• Do not use the DC coupler provided with your EOS D30 with any other camera.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment