Canon G7 How To Check Charge

EZ Battery Reconditioning Method

How to Repair Old Batteries at Home

Get Instant Access

Battery charge is low. Recharge it as soon as possible it will be used for an extended period.

will display.

Change the batteries

Battery charge is insufficient to operate the camera. Replace the battery immediately.

Battery Handling Precautions

Keep the battery terminals clean at all times.

Dirty terminals may cause poor contact between the battery and camera. Polish the terminals with a soft cotton swab before charging or using the battery.

At low temperatures, battery performance may be reduced and the low battery icon ) may appear earlier than usual.

Under these conditions, revive the battery by warming it in a pocket immediately before use.

However, ensure that there are no metallic items in the pocket that could cause a short circuit, such as a key ring, etc.

The battery may short circuit.

Do not allow any metal objects such as key rings to touch the ((+)) and (Q) terminals (Fig. A). To carry the battery or store it during periods of disuse, always replace the terminal cover (Fig.B).

These conditions can damage the battery. You may be able to check the charge state depending upon how the terminal cover is attached (Fig. C, D).

The Lithium ion/polymer battery that powers the product is recyclable.

Please call 1-800-8-BATTERY for information on how to recycle this battery.

Fully Charged Battery

Used Battery

Fully Charged Battery

Insert the battery pack so the blue area is visible.

Used Battery

Attach in the opposite way of Fig. C.

Insert the battery pack so the blue area is visible.

Attach in the opposite way of Fig. C.

> You are recommended to use it in the camera until it is completely discharged and to store it in an indoor location with low relative humidity and between the temperatures of 0 - 30 °C (32 - 86 °F).

Storing a fully charged battery for long periods of time (about one year) may shorten its life cycle or affect its performance. If you do not use the battery for long periods of time, charge it fully and discharge it fully in the camera about once a year before returning it to storage.

> Do not mix batteries of different types or from different manufacturers.

Charging the Battery

> Since this is a lithium-ion battery, you need not completely discharge it before recharging.

> It takes approximately 1 hours 30 minutes to fully charge the battery from a depleted state (based on Canon's testing standards).

• Charging it within a temperature range of 5 - 40 °C (41 -104 °F) is recommended.

• Charge times may vary according to the ambient temperature and the battery's charge state.

> You are advised to charge the battery on the day of use, or one day before, to ensure a full charge.

Even charged batteries continue to discharge naturally.

> If the performance of the battery diminishes substantially even when it is fully charged, its life has been exceeded and it should be replaced.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment