2nd Curtain Switch Spring
2nd Curtain jump suppressor
-" 2nd Curtain * drive spring
1st Curtain jump suppressor
181 Curtain drive spring
Assemble and disassemble in released condition
Whe changing shutter blades apply a small amount of Astrooil to the pivot shafts.
Hook on edge of blade (Check before dlaasscnbly ^ ** :the aPrin8 1® not under' ^ In the released con-
Hook on edge of blade (Check before dlaasscnbly ^ ** :the aPrin8 1® not under' ^ In the released con-
Identical washers (S) & (12) are thicker than identical washers (4) & (13)
Hook in hole in blade (Check before load§whpn rh" 9ptin* ls not load when the shutter is released.
Hook in hole in blade (Check before load§whpn rh" 9ptin* ls not load when the shutter is released.
Identical washers (S) & (12) are thicker than identical washers (4) & (13)
Numbers thru (16)
Grip Head Unit Disassembly
Rotoied ISO
A8 the final step install (2)-5 and (2)-6 in this hole. (2)-6 goes in slanted.
Numbers Thru
"Part Name |
Adiustments (In order from the left) |
Main Flex Unit* |
m, VR2 , VR3 , VR4 , VR1 , VR5 . VR6 , VR7. |
Ft) Flex Unit |
N/A |
Motor Flex Unit |
N/A |
DX Flex Unit |
N/A (DX Sensor Unit is service part) |
Spot Flex Unit |
N/A |
Shutter Flex Unit |
N/A |
DC/DC Convertor |
N/A |
Was this article helpful?
Post a comment